Ryobi CDI-1801M Especificações descarregar pdf (Página 26)

-23-

Facing the ridge of the Shift Arm [24] toward the Motor [36] side, mount the Shift Arm [24] on the

unmarked side of the assembly that was reassembled in step (b) above. Then insert the protrusions of

the Shift Arm [24] into the holes of the Rear Case [22] and make sure that the protrusions fit into the

grooves of the Slide Ring Gear [25] mounted in the Rear Case [22]. (See Fig. 11.)

(d) Mount the Drill Chuck 13VLRS-N [2].

Mount the Drill Chuck 13VLRS-N [2] by using the special repair tool (J-348, Code No. 349-886), and

then secure it with Flat Hd. Screw (A) (Left Hand) M6 x 25 [1].

(e) Mount the Shift Knob [37] onto the assembly that was reassembled in step (d) above.

When mounting the Shift Knob [37] to the Shift Arm [24], check that the “LOW” mark on the Shift Knob

[37] faces the Motor [36] with the Shift Arm [24] fitted into the recess of the Shift Knob [37].

Hole

Ridge

Groove

View of C

Mark

Fig. 9 Fig. 10

Position of Spring (A) [16]

and Steel Ball D5 [17]

Recesses

Recess

Fig. 11

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 44 45

Sem comentários

Ryobi CDI-1801M Especificações Página 26