Ryobi PLT3043A, RY70101A Manual do Operador

OPERATOR’S MANUALTrimmerPLT3043ARY70101Your new trimmer has been engineered and manufactured to Ryobi’s high standard for dependability, ease of opera

10TO START A COLD ENGINE:1. Lay trimmer on a flat, bare surface. Move switch to “I”(RUN) position.NOTE: Unit is equipped with a positive on-off swi

11MAINTENANCE WARNING:Use only original manufacturer’s replacement parts,accessories and attachments. Failure to do so cancause possible injury, poor

12STRING REPLACEMENTSee Figures 12, 13, 14 and 15.1. Stop the engine, disconnect the sparking plug wire. Holdthe string head and unscrew the spool ret

13The fuel cap contains a non-serviceable filter and a checkvalve. A clogged fuel filter will cause poor engine perfor-mance. If performance improves

14PROBLEMPROBLEMPROBLEMPROBLEMPROBLEMPOSSIBLE CAUSEPOSSIBLE CAUSEPOSSIBLE CAUSEPOSSIBLE CAUSEPOSSIBLE CAUSESOLUTIONSOLUTIONSOLUTIONSOLUTIONSOLUTIONIF

151“H” HIGHNEEDLEPROBLEMPROBLEMPROBLEMPROBLEMPROBLEMPOSSIBLE CAUSEPOSSIBLE CAUSEPOSSIBLE CAUSEPOSSIBLE CAUSEPOSSIBLE CAUSESOLUTIONSOLUTIONSOLUTIONSOLU

16SOUND POWER/PRESSURE AND HANDLE VIBRATION CHART FOR TRIMMERS /BRUSHCUTTERSInformation on Noise Emission per European Machine Safety Directive 98/37/

17NOTES

983000-2002-03OPERATOR’S MANUALTrimmerPLT3043ARY70101Ryobi Technologies GmbHItterpark 7D-40724 HildenGermanyTel.: +49 (0)2103 / 29 58 0Fax : +49 (0)21

2TABLE OF CONTENTSSAFETY WARNING:Do not attempt to operate this trimmer until you have read thoroughly and understand completely all instructions,saf

3SAFETYQQQQQ Secure long hair so it is above shoulder level to prevententanglement in any moving parts.QQQQQ Keep all bystanders, children and pets at

4SYMBOLSImportant: Some of the following symbols may be used on your tool. Please study them and learn their meaning.Proper interpretation of these sy

5SYMBOLSThe purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanationswith them, deserve you

6FEATURESFig. 1THROTTLE TRIGGERSILENCERGUARDSTARTER GRIPCHOKE LEVERTHROTTLE CONTROLAND REAR HANDLEFRONT HANDLEDRIVE SHAFTHOUSINGSTRING HEADGRASS DEFLE

7ASSEMBLYSILENCER GUARD ASSEMBLYSee Figure 4.1. Remove silencer guard and two screws from theowner’s kit.2. Attach the silencer guard to the rear hous

8FILLING THE TANK1. Clean surface around fuel cap to prevent contamination.2. Loosen fuel cap slowly to release pressure and to keepfuel from escaping

9OPERATIONADVANCING THE STRINGADVANCING STRING USING THE EZ LINE™ TAPADVANCE SYSTEMString advance is controlled by tapping string head on grasswhile r