Ryobi RY52905 Manual do Operador Página 1

OPERATOR’S MANUALTP30 GAS PRUNERRY52504/RY52905SAVE THIS MANUAL FOR FUTURE REFERENCEYour pruner has been engineered and manufactured to our high stand

10ASSEMBLYFILLING TANK Clean surface around fuel cap to prevent contamina-tion. Loosen fuel cap slowly. Rest the cap on a clean su

11WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict ser

12OPERATIONFig. 7CUTTING GUIDEFig. 6NOTE: For second and final cuts (from top of limb or branch), hold front cutting guide against the limb being cu

13OPERATIONFig. 12POSITION FOR STARTINGSee Figure 9.Lay the pruner on the ground and ensure that no objects or obstructions are in the immediate vicin

14fLATSAPPROX .050 in.Fig. 14Fig. 13WARNING:When servicing, use only identical replacement parts. Use of any other parts may create a hazard

15MAINTENANCEREPLACING THE BAR AND CHAINSee Figures 15 - 20.WARNING: To avoid possible serious injury, stop engine before re-placing the bar, chain, o

16IDLE SPEED ADJUSTMENTSee Figure 21.If the chain turns at idle, the idle speed screw needs adjusting on the engine. Turn the idle speed screw counter

17MAINTENANCECUTTING CORNERSIDE PLATEDEPTH GAUGETOEGULLETHEELRIVET HOLETOP PLATEPARTS Of A CUTTERFig. 24HOW TO SHARPEN THE CUTTERSSee Figures 24 - 27.

18MAINTENANCECLEANING AIR FILTER SCREENSee Figure 28-29.For proper performance and long life, keep air filter clean. Remove the air filter cover by

19TROUBLESHOOTINGPROBLEM POSSIBLE CAUSE REMEDYEngine will not start. No spark. No fuel. Engine is flooded. Starter rope pulls harder now than whe

2 Introduction ...

20WARRANTYLIMITED WARRANTY STATEMENTTechtronic Industries North America, Inc., warrants to the original retail purchaser that this RYOBI® brand outdoo

21WARRANTYTHE FOLLOWING CALIFORNIA AIR RESOURCES BOARD (CARB) STATEMENT ONLY APPLIES TO MODEL NUM-BERS REQUIRED TO MEET THE CARB REQUIREMENTS.The U.S.

22EMISSIONS MAINTENANCE SCHEDULE AND WARRANTED PARTS LISTEmissions Parts Inspect Before Clean Every Replace Clean Every Replace Every Each U

23NOTES

987000-19410-18-07 (REV:01)OPERATOR’S MANUALTP30 GAS PRUNERRY52504/RY52905 WARNING:The engine exhaust from this product contains chemicals known to t

3WARNING!Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious pers

4Kickback is a dangerous reaction that can lead to serious injury. Kickback may occur when the moving chain con-tacts an object at the upper portion

5SYMBOLSSome of the following symbols may be used on this product. Please study them and learn their meaning. Proper inter-pretation of these symbols

6SYMBOLSSERVICEServicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we su

7 FEATURESFig. 1PRODUCT SPECIFICATIONSEngine Displacement...

8ATTACHING THE “J” HANDLESee Figure 2. Hold the top and bottom clamp snugly in position on the shaft housing so that the handle will be located to t

9 Reinstall the bolt, lock washer, and hex nut to secure. Connect the latch on the shoulder harness to the strap hanger.ASSEMBLYCONNECTING THE P