Ryobi BD4600 Manual do Operador descarregar pdf (Página 12)

OPERATION

Fig. 14

TABLE

LOCK

KNOB

BEVEL SANDING

See Figure 14.

The worktable can be tilted from 0° to 45° for bevel sanding.

To tilt the worktable:

■ Loosen the table lock knob by turning it counterclockwise.

■ Set worktable to desired angle.

Note: Position the worktable not further than 1/16 in.

(1.6 mm) from the sanding surface.

■ Tighten the table lock knob by turning it clockwise.

SANDING SMALL END SURFACES USING THE

MITER GAUGE

See Figure 15.

A miter gauge is included with your tool for increased

accuracy. Use of a miter gauge is recommended for sanding

small end surfaces on the sanding disc.

Note: Always move the workpiece across the sanding disc

from the left side towards the right side.

HORIZONTAL AND VERTICAL SANDING

See Figure 16.

Your belt/disc sander can sand both vertically and

horizontally. Depending on the workpiece, the work support

can be used with either the horizontal or vertical sanding

operation.

■ Insert the hex key provided into the holes in the pulley

cover. Loosen the screws by turning them counter-

clockwise.

■ Move the sanding belt into a vertical position as shown

in Figure 16. Vertical position can be changed using the

vertical set screw.

■ Lock the sanding belt by retightening the screws.

Note: Sand long workpieces with the sanding belt in the

vertical position by moving the work evenly across the

sanding belt.

Fig. 15

4 x36

Fig. 16

VERTICAL

POSITION

HOLE

MITER GAUGE

HORIZONTAL

POSITION

HOLE

1/16 IN OR

LESS

VERTICAL

SET SCREW

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários

Ryobi BD4600 Manual do Operador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas Ryobi BD4600