Ryobi RY09440 Manual do Utilizador descarregar pdf

WARNING: This Engine Starting Procedure is not a substitute for reading

the operator’s manual. To reduce the risk of injury, user must read and under-

stand operator’s manual before using this product.

Pour fresh gasoline into the fuel tank.

Slowly press the PRIMER BULB 10x or until fuel appears.

Pull starter handle until engine attempts

to start (4X max.)

RYOBI ART WORK

Art Part No. : 987000-840 Rev. 03

Where Used : 987000-840

Refer to Drawings for Dimensions.

987000-840

8-18-10 (REV:03)

1 GALLON

GAS

ENGINE STARTING PROCEDURE

Material: 60lb. Stock Paper.

Color: Orange Yellow.

FRONT

For any questions about operating or maintaining your product, call the Ryobi

Help Line !

Your product has been fully tested prior to shipment to ensure your complete satisfaction.

Troubleshooting tips are also available in your operator’s manual.

Go to www.ryobitools.com and register your new tool on-line.

CALL

1-800-860-4050

www.ryobitools.com

TO START:

PRESS and HOLD stop switch until

engine stops.

TO STOP:

SET throttle/cruise control lever to IDLE.

SET choke lever to FULL choke.

SET choke lever to HALF choke.

Pull starter handle until engine starts (6X max.)

NOTE: If the unit has not started, return to step 3.

Allow the engine to warm for 10 seconds,

SET choke lever to RUN.

TO RESTART A WARM ENGINE:

If the engine/unit is already hot:

Set the throttle/cruise lever to IDLE. Do not squeeze the throttle to start a hot engine.

SET choke lever to RUN.

Pull starter handle until engine starts (6X max.)

LUBRICANT

First time use only:

Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.

Later uses:

Check engine lubricant level and add lubricant if needed.

PRIME

SET TO

x10

LOCK

THROTTLE LEVER

SET TO

WAIT 15 SEC

SET TO

(4X MAX)

PULL UNTIL

ENGINE STARTS

PULL UNTIL

ENGINE ATTEMPTS

TO START

(6X MAX)

1 2

Resumo do Conteúdo

Página 1 - ENGINE STARTING PROCEDURE

WARNING: This Engine Starting Procedure is not a substitute for reading the operator’s manual. To reduce the risk of injury, user must read an

Página 2 - 1-800-860-4050

RYOBI ART WORKArt Part No. : 987000-840 Rev. 03Where Used : 987000-840 Refer to Drawings for Dimensions.Procédure de démarrage du mot

Mais documentos para Ferramentas elétricas Ryobi RY09440

Para ver o documento Ryobi RY09440 Manual do Utilizador

Ryobi RY09440 Manual do Utilizador (48 páginas)

Comentários a estes Manuais

Sem comentários

Ryobi RY09440 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Ferramentas elétricas Ryobi RY09440. Ryobi RY09440 Manuel d'utilisation Manual do Utilizador

Resumo do Conteúdo

Mais documentos para Ferramentas elétricas Ryobi RY09440

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas Ryobi RY09440