Page 12
ADJUSTMENTS
Fig. 9
Fig. 10
QUICK LOCK-RELEASE LEVER
WITH THREADS NOT ENGAGED
VISE
CLAMP
VISE CRANK
HANDLE
VISE
SCREW
VISE
CLAMP
VISE CRANK
HANDLE
QUICK LOCK-RELEASE LEVER
WITH THREADS ENGAGED
■ Using the 8 mm hex key supplied, securely tighten socket
head bolts. Return hex key to its storage area in base.
■ This position is good for cutting thin and wide pieces of
stock, such as flat or angled stock.
■ To increase the height of cut of your cut-off machine,
follow the above procedure except place the rear socket
head bolt in the middle threaded hole and the front socket
head bolt in the front threaded hole.
■ Check and adjust fence to desired cutting angle.
■ Using the 8 mm hex key supplied, securely tighten socket
head bolts. Return hex key to its storage area in base.
■ This position is good for cutting tall and thick pieces of
stock, such as square or tube stock.
QUICK LOCK-RELEASE LEVER
See Figures 9 and 10.
The quick lock-release lever engages the vise clamp to be
used along with the fence to provide a vise for securing the
workpiece to be cut. It also allows you to open and close the
vise quickly without repetitive turning of the vise crank
handle.
USING THE QUICK LOCK-RELEASE LEVER
AND VISE CLAMP
To loosen:
See Figure 9.
■ Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
■ Release tension on the vise clamp by rotating the vise
crank handle 1/2 to 1 turn counterclockwise.
■ Lift up the quick lock-release lever as shown in figure 9
and pull back on vise crank handle to slide open the vise.
To tighten:
See Figure 10.
■ Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
■ Push the vise crank handle forward to slide the vise clamp
against the workpiece.
■ Rotate the quick lock-release lever forward and push
down as shown in figure 10 to engage its threads with
the vise screw.
■ Rotate the vise crank handle clockwise to tighten the vise
clamp against the workpiece.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais