Ryobi P715 Manual do Operador descarregar pdf

OPERATOR’S MANUAL

18 VOLT SPOTLIGHT

P715

SAVE THIS MANUAL FOR FUTURE REFERENCE

Your spotlight has been engineered and manufactured to our high standard for dependability, ease of operation, and operator

safety. When properly cared for, it will give you years of rugged, trouble-free performance.

WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using

this product.

Thank you for your purchase.

BATTERIES AND CHARGERS SOLD

SEPARATELY

ACCEPTS ALL ONE+ BATTERY PACKS

1 2 3 4 5 6 7 8 9 10

Resumo do Conteúdo

Página 1 - OPERATOR’S MANUAL

OPERATOR’S MANUAL18 VOLT SPOTLIGHTP715SAVE THIS MANUAL FOR FUTURE REFERENCEYour spotlight has been engineered and manufactured to our high standard fo

Página 2 - WARRANTY

10OPERATOR’S MANUAL18 VOLT SPOTLIGHTP715P715987000-15109-24-07 (REV:01)• PARTS AND SERVICEPrior to requesting service or purchasing replacement parts

Página 3 - IMPORTANT SAFETY INSTRUCTIONS

2Introduction ...

Página 4 - SAVE THESE INSTRUCTIONS

3GENERAL SAFETY RULESWARNING!READ AND UNDERSTAND ALL INSTRUCTIONS. Fail-ure to follow all instructions listed below, may result in electric shock, fir

Página 5 - ASSEMBLY

4SYMBOLSSome of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation

Página 6 - OPERATION

5FEATURESFig. 1PRODUCT SPECIFICATIONSBulb ...6 V HalogenWeight ...

Página 7

6PULL TAB TO REMOVEFig. 2REMOVING THE WARNING LABELSee Figure 2.The spotlight has a cling-type attached warning label on the lens. Remove this

Página 8 - MAINTENANCE

7OPERATIONDEPRESS BOTH LATCHES TO RELEASEFig. 3ALIGN RAISED RIB ON BATTERY PACK WITH GROOVE IN BATTERY PORT TO INSTALL BATTERY PACKSee Figures 3 - 4.

Página 9

8MAINTENANCEWARNING:When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product

Página 10

9MAINTENANCEBULBASSEMBLYFig. 7RETAINERPINCAUTION:Do not use a higher rated fuse other than the specified amperage. This could cause damage to the prod