Ryobi YN301PL1 Manual do Operador descarregar pdf (Página 14)

14 - English

MAINTENANCE

WARNING:

When servicing use only identical Ryobi® replacement

parts. Use of any other parts may create a hazard or

cause product damage.

WARNING:

Always wear eye protection marked to comply with ANSI

Z87.1 during maintenance. If operation is dusty, also

wear a dust mask.

WARNING:

Always release all pressure, disconnect from power

supply, and allow unit to cool to the touch before cleaning

or making repairs on the air compressor.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

 Any continued loss of air after performing the above steps

indicates a problem with the safety valve. Discontinue

use and seek service before continued use of the air

compressor.

OPERATION

WARNING:

If air leaks after the ring has been released or if the valve is

stuck and cannot be actuated by the ring, do not use the

air compressor until the safety valve has been replaced.

Use of the air compressor in this condition could result

in serious personal injury.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal injury.

Electric tools used on fiberglass material, wallboard,

spackling compounds, or plaster are subject to

accelerated wear and possible premature failure because

the fiberglass chips and grindings are highly abrasive to

bearings, brushes, commutators, etc. Consequently, we

do not recommend using this product for extended work

on these types of materials. However, if you do work with

any of these materials, it is extremely important to clean

the product using compressed air.

LUBRICATION

All of the bearings in this product are lubricated with a

sufficient amount of high grade lubricant for the life of the

unit under normal operating conditions. Therefore, no further

lubrication is required.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 16

AFTER SPANISH LANGUAGE SECTION.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comentários a estes Manuais

Sem comentários

Ryobi YN301PL1 Manual do Operador Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Compressores de ar Ryobi YN301PL1