17
MAINTENANCE
BLADE
WRENCH
SCREWS
BLADE CLAMP
CHANGING BLADES
See Figures 14 - 16.
The planer blades are reversible. When one edge becomes
dull, the blade can be reversed so that the other side can
be used.
Always replace or reverse blades in pairs. Do not attempt
to sharpen blades. If the blades in the planer show signs
of becoming dull, chipped, or damaged in any way, replace
them.
When changing blades, use the recommended replacement
blades only (Part No. 671798001).
WARNING:
The blades are sharp. Use extreme caution when
replacing blades. Failure to heed this warning can result
in serious personal injury.
Remove the battery pack from the tool.
Secure the planer in an upside-down position.
Loosen the two screws securing the blade and blade
clamp on the blade holder using the blade wrench
provided. Loosen the screws just enough to remove the
old blade.
NOTE: If screws are too loose, alignment of the new blade
will not be accurate.
NOTE: Before removing the old blades, take notice of
the direction of cut as well as how the tapered edge of
the old blades are oriented. The tapered edge of the new
blades must be in the same orientation as the original
blades, with the tapered edge on the same side as the
screw heads and the flat edge facing the cutter block.
Push the blade (to the right) out of the blade holder using
the tip of a screwdriver.
Remove the old blade from the blade holder.
NOTE: If you cannot easily push the blade out of the blade
holder after loosening the screws, use a block of wood
to break the blade loose from the blade holder. Give the
blade a short, sharp blow, then push it with a screwdriver
to remove. If necessary, tap the block of wood sharply
with a small hammer to break the blades loose.
Clean any sawdust or wood chips from around the blade
area.
Slide the new blade into the slot of the blade holder.
Use a screwdriver to push the blade into the blade holder
until it is centered into position.
Tighten the two screws using the blade wrench.
Repeat the above procedure to change the other blade.
Fig. 14
Fig. 16
INSERTING THE
NEW BLADE
BLADE HOLDER
SLOT
Fig. 15
REMOVING THE
OLD BLADE
CUTTER
BLOCK
(14 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais