Ryobi P530 Manual do Operador descarregar pdf (Página 13)

USING CIRCLE CUTTER

See Figure 9.

Assemble circle cutter if necessary. Refer to “Assembling

Circle Cutter” in this manual.

Attach circle cutter to speed saw if necessary. Refer to

“Attaching Circle Cutter” in this manual.

Adjust depth of cut if necessary. Refer to “Adjusting

Depth Of Cut” in this manual.

Loosen pivot point knob.

Move pivot point knob to desired diameter dimension.

Tighten pivot point knob.

Start speed saw.

Cut a pilot hole in the center of the intended circle.

Line up pivot point knob with the lead hole.

Begin cut, applying moderate, steady pressure.

Hold the speed saw firmly with one hand and the handle

with the other.

CAUTION:

Too much force causes heat build up, which can shorten

the life of the bit.

Work in a clockwise direction, continuing back to the

starting position.

Stop speed saw.

Fig. 9

OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16

Sem comentários

Ryobi P530 Manual do Operador Página 13