Ryobi SB720R Manual do Operador Página 17
- Página / 26
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
CHECKING THE OIL LEVEL
CAUTION: To prevent extensive engine wear
and damage to the unit, always maintain the
proper oil level in the crankcase. Never
operate the unit with the oil level below the
bottom of the dipstick.
The importance of checking and maintaining the proper
oil level in the crankcase cannot be overemphasized.
Check oil before each use:
1. Stop engine and allow oil to drain into the crankcase.
2. Place the unit on a flat, level surface to get a proper
oil level reading.
3, Keep dirt, grass cSppings, etc., out of the engine.
Clean the area around the oil fill plug/dipstick before
removing it.
4. Remove the oil fill plug/dipstick and wipe off oil.
Reinsert it all the way back in.
5. Remove the oil fill plug/dipstick and check oil level.
Oil should be up to the top of the dipstick (Fig. 22).
CHANGING THE OIL
For a new engine, change the oil after the first 10 hours
of operation. Thereafter, change the oil after every 25
hours or before storing the unit for an extended period of
time.
It is best to change the oil while the engine is still warm.
The oil will flow freely and carry away more impurities.
CAUTION: Wear gloves to prevent injury ]
when handling the unit.
r
1. Unplug spark plug boot to eliminate starting
2. Remove the oil fill plug/dipstick.
3. Pour the oil out of the oil fill hole and into a container
by tipping the unit to a vertical position (Fig. 24).
Allow ample time for complete drainage,
O-Ring
-Top of Dipstick
Fig. 22 ..........
6. If the level is low, add a small amount of oil to the oil
fill hole and recheck (Fig. 23). Repeat until the oil
level reaches the top of the dipstick.
NOTE: Do not overfill the unit.
Oil Fill
.... Fig.23 ..........
NOTE: Make sure the O-ring is in place on the oil fill
plug/dipstick when checking and changing the
oil (Fig, 23).
-_ Fig.24
4, Wipe up any oil residue on the unit and clean up any
oil that may have spilled. Dispose of the oil
according to Federal, State and local regulations,
5. Refitt the crankcase with 3.4 tluid oz (100 ml) of SAE
30 SF, SG, SH oil. Use the bottle and spout from
initial use to measure the correct amount.
6. Replace the oil fill plug/dipstick.
7. Reconnect spark plug boot.
17
- OPERATOR'S MANUAL 1
- ENGINEDISPLACEMENT:26.2c¢ 3
- ENGINEFAMILY:WN4XS.O264AO J 3
- ANDADJUa"TMENTSj// 3
- 5-7x • PRIMER BULB 6
- ....... Fig, 2 9
- Fuel Cap --I_ O 10
- Start / Stop 11
- Throttle Control _ 11
- ...... Fig. 6 11
- D Handle 13
- 4 Screws 13
- - Fig. 12 13
- Indexing Teeth I 15
- ...... Fig. 18 15
- Outer Spool 15
- TM to make sure it 16
- TM if dam 16
- -Top of Dipstick 17
- Oil Fill 17
- Air Filter Cover 18
- Choke Lever 18
- Back Plate 18
- ............. Fig. 26 18
- .... Fig. 3() 19
- • Loosen Screws 20
- Rocker Arm 20
- Adjusting Nut 20
- Gasket Feeler Gauge 20
- LONG TERM STORAGE 22
- LIMITED TWO-YEAR WARRANTY 26
Manuais e produtos relacionados com Roçadora corta-relva Ryobi SB720R
Roçadora corta-relva Ryobi SB720R Manual do Operador
(30 páginas)
(30 páginas)
Roçadora corta-relva Ryobi RBC52FSB Manual do Utilizador
(252 páginas)
(252 páginas)
Roçadora corta-relva Ryobi RLT5030 Manual do Utilizador
(104 páginas)
(104 páginas)
(239 páginas)
Roçadora corta-relva Ryobi 767rj Manual do Operador
(28 páginas)
(28 páginas)
Roçadora corta-relva Ryobi P2601 Manual do Operador
(34 páginas)
(34 páginas)
Roçadora corta-relva Ryobi RPT400 Manual do Utilizador
(210 páginas)
(210 páginas)
Roçadora corta-relva Ryobi P2200 Manual do Operador
(44 páginas)
(44 páginas)
Roçadora corta-relva Ryobi P2004 Manual do Operador
(34 páginas)
(34 páginas)
Samsung SMC-102P Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Nein Samsung SMC-102P.
Wir stellen 1 PDF-Handbücher Samsung SMC-102P zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentários a estes Manuais