Ryobi BTS10S Manual do Operador

RYOBI OPERATOR'S MANUAL10 in. (254 mm) TABLE SAWModel BTS10THANK YOU FOR BUYING A RYOBI TABLE SAW.Your new Table Saw has been engineeredand manuf

_ WARNING: IDo not connect to power supply until assembly iscomplete. Failure to comply could result in accidentalstartingand possibleseriouspersonal

Attach blade guard assembly to support bracket withM6 x 19 mm carriage bolt. Secure with a 1/4" flat washer,external tooth lock washer and wing n

WARNING:Yourtablesaw has a precision built electric motor. Itshouldonly be connected to a power supply that is 120 volts,60 Hz, AC only (normal househ

CALIBRATING AND ADJUSTING YOUR SAW BEVEL ADJUSTMENTSWARNING:Before performing any adjustmentsor calibrations, makesure the table saw is unpluggedfrom

3,For through-cuts, place the workpiece to be cut flushagainst the blade. Set the blade so that the tips of theuppermost tooth are about an 1/8"

MAKING CUTSThere are seven basic types of cuts:Straight Cross CutCut made across the grain.Fig. 1_Miter Cross CutCut made with the workpiece at an ang

This section deals with the proper procedures for makingthese seven basic cuts.CUTTING TIPSThe kerf (the cut made by the blade in the wood) will bewid

5. Position the workpiece flat on the table with the edgeflush against the miter gauge. Let the blade build up tofull speed before feeding the workpie

TO MAKE A BEVEL RIP CUTIt is recommended that you place the piece to be saved onthe right side of the blade and that you make a test cut onscrap wood

1. Removethewing nut and carriage bolt holding the bladeguard assembly to the blade guard support bracket. SeeFigure 24. Remove the blade guard assemb

Table of Contents ...

SAFETY CONSIDERATIONSAVOIDING KICKBACKKickback can occur when the blade stallsor binds, kickingthe workpieca back toward the front of the saw with gre

GENERAL MAINTENANCEWARNING:Always begin any maintenance procedure bydisconnecting the saw from the power supply to avoidrisk of serious personal injur

Problem SolutionExcess Vibration,Rip fence does not operatesmoothly.Cutting binds or burns work.Possible Cause1. Blade is out of balance.2. Blade is w

Page23

RYOBI oPE ToR'sMA.UA,10 in. (254 mm) TABLE SAWModel BTS10EXTENSION CORD CAUTIONIVhen usinga power toolat a considerabledistancefrom a powersource

The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and theexplanations with them, deserve your carefu

READAND UNDERSTAND ALL INSTRUCTIONS 18.1. Know your power tool. Read and understand theoperator'smanualcarefully.Learnthesaw'sapplicationsan

29. Do not use tool if switch does not turn it on and off.Have defectiveswitchesreplaced by a qualifiedservicetechnicianat an authorized Ryobi Service

• Never perform any operation freehand, which meansusingonlyyourhands to supportorguidethe workpiece.Always use either the rip fence or the miter guid

HeelMisalignmentoftheblade,KerfThe amount of material removed by the blade in a through-cut, or the slot produced by the blade in non-through or parti

Your Model BTS10 Table Saw is shipped complete in onecarton and includes rip fence, miter gauge, blade guard,accessory storage brackets, wrenches, Ope

Know Your Table SawYour saw is designed to perform as a versatile, accurate,precision wood cutting tool that is easy to operate. It isequipped withthe