Ryobi CSB133L Manual do Operador descarregar pdf (Página 17)

OPERATION

LENGTH OF CUT SCALE

See Figure 16.

The saw is equipped with a length of cut scale on its base.

It is parallel with the saw blade and can be used to measure

the distance into the material the blade cuts.

NOTE: Six inches is the maximum length of cut that you can

measure. Also, it is accurate only when the depth of cut is

set at full maximum depth.

CROSS CUTTING/RIP CUTTING

See Figures 17 - 18.

When making a cross cut or rip cut, align the line of cut

with the outer blade guide notch on the base as shown in

the figure.

Since blade thicknesses vary, always make a trial cut in scrap

material along a guideline to determine how much, if any, you

must offset the guideline to produce an accurate cut.

NOTE: The distance from the line of cut to the guideline is

the amount you should offset the guide.

TO RIP CUT WITHOUT EDGE GUIDE

See Figure 18.

Use a guide when making long or wide rip cuts with the

saw.

NOTE: You may also use a edge guide to make rip cuts. Refer

to OPTIONAL EDGE GUIDE later in this manual.

Secure the workpiece.

Clamp a straight edge to the workpiece using

C-clamps.

Saw along the straight edge to achieve a straight rip

cut.

NOTE: Do not bind the blade in the cut.

BEVEL CUTTING

See Figures 19 - 20.

To make the best possible cut, follow these helpful hints.

Align the line of cut with the inner blade guide notch on

the base when making 45° bevel cuts.

Make a trial cut in scrap material along a guideline to

determine how much you should offset the guideline on

the cutting material.

Adjust the angle of the cut to any desired setting between

zero and 51.5°. Refer to TO ADJUST BEVEL SETTING

next.

TO ADJUST BEVEL SETTING

See Figure 20.

Unplug the saw.

Loosen bevel adjustment knob.

Raise motor housing end of saw until you reach desired

angle setting on bevel scale.

Tighten bevel adjustment knob securely.

Fig. 16

LeNGTH Of

CUT SCaLe

TOP VIew Of Saw

GUIDeLINe

BLaDe

GUIDe NOTCH

Fig. 17

Fig. 18

wOrKPIeCe

GUIDeLINe

C-CLaMP

STraIGHT

eDGe

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Ryobi CSB133L Manual do Operador Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares Ryobi CSB133L