Ryobi HPL51 Manual do Operador descarregar pdf (Página 15)

MAINTENANCE

REPLACING BLADES

See Figures 13 - 15.

The planer blades are reversible. When one edge becomes

dull, the blade can be reversed so that the other side can

be used.

Always replace or reverse blades in pairs. Do not attempt

to sharpen blades. If the blades in the planer show signs

of becoming dull, chipped, or damaged in any way, replace

them.

When replacing the blades, use recommended replacement

blade only, Ryobi part number 6986101.

WARNING:

The blades are sharp. Use extreme caution when

replacing blades. Failure to heed this warning can result

in serious personal injury.

 Unplug the planer.

 Secure the planer in an upside-down position.

 Loosen the three screws securing the blade on the blade

holder using the blade wrench provided.

NOTE: Do not over-loosen the screws. If screws are too

loose, alignment of the new blade will not be accurate.

NOTE: Before removing the old blades, take notice of

the direction of cut as well as how the tapered edge of

the old blades are oriented. The tapered edge of the new

blades must be in the same orientation as the original

blades, with the tapered edge on the same side as the

screw heads and the flat edge facing the cutter block.

 Push the blade (to the right) out of the blade holder using

the tip of a screwdriver.

 Remove the old blade from the blade holder.

NOTE: If blade cannot be easily pushed out of blade

holder after loosening blade securing screws, use a

block of wood to break the blade loose from the blade

holder with a short sharp blow. Then push the blade with

a screwdriver to remove. If necessary, tap the block of

wood sharply with a small hammer to break the blade

loose.

 Clean any sawdust or wood chips from around the blade

area.

 Slide the new blade into the slot of the blade holder.

 Use a screwdriver to push the blade into the blade holder

until it is centered into position.

 Retighten the three blade securing screws using the blade

wrench.

 Repeat the above procedure to change the other blade.

BLADE

WRENCH

SCREWDRIVER

BLADE

HOLDER

SCREW

Fig. 15

Fig. 13

Fig. 14

1 2 ... 10 11 12 13 14 15 16 17 18

Comentários a estes Manuais

Sem comentários

Ryobi HPL51 Manual do Operador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas Ryobi HPL51